Freightliner FLD Conventional — FLD Conventional

Steering and Brake Systems bring the vehicle to a complete stop in the saf- est location possible. be pulled out when operating a vehicle without a trailer. If pressure in both air systems drops to 35 to 45 psi (242 to 310 kPa), the red knob automatically pops out, exhausting the trailer air supply, and apply- ing the trailer service or spring parking brakes. NOTE: If equipped with main and auxiliary transmissions, do not shift both transmissions into Neutral while the vehicle is rolling. Shifting both transmissions back into gear would be diffi- cult while the vehicle is rolling. 1 2 The trailer brake hand control valve ( Fig.

6.2 ) actu- ates the trailer service brakes independently from the vehicle chassis service brakes. The valve can be partially or fully applied, but in any partially-on posi- tion it will be overridden by a full application of the foot brake control pedal. Moving the valve handle clockwise actuates the trailer brakes, while moving it counterclockwise releases the trailer brakes. The valve handle remains in the position selected until it is manually moved. TRACTOR ONLY PARKING BRAKES PULL PARKING BRAKES CONTROL THEN PUSH TRAILER AIR CONTROL 24−227−0 f600503 08/27/93 1. Trailer Air Supply Valve Knob 2. Parking Brake Valve Knob Fig.

6.3, Trailer Air Supply/Parking Brake Control Panel 1 2 The yellow diamond-shaped knob ( Fig. 6.3 ) in the control panel actuates the parking brake valve. Pull- ing out the knob applies both the tractor and the trailer spring parking brakes and automatically causes the trailer air supply valve knob to pop out. 3 CAUTION 11/06/98 f460002b 1. Turn Signal Lever 2. Trailer Brake Hand Control Valve 3. Hazard Warning Light Tab Do not use the spring parking brakes if the ser- vice brakes are hot, such as after descending a steep grade. Also, do not use the spring parking brakes during freezing temperatures if the ser- vice brakes are wet.

To do so could damage the brakes if hot, or cause them to freeze during cold weather. Fig. 6.2, Steering Column-Mounted Controls WARNING Do not use the trailer service brakes for parking; they are not designed for this purpose. If air bleeds out of the trailer air tank during parking, the vehicle could roll causing serious personal injury or property damage. If the brakes are wet, drive the vehicle in low gear and lightly apply the brakes to heat and dry them. Allow hot brakes to cool before using the spring parking brakes. Always chock the tires.

If the trailer is not equipped with spring parking brakes, pulling out the yellow knob applies the tractor spring parking brakes and the trailer service brakes. When the tractor and trailer parking brakes (or trailer service brakes) are both applied, the trailer brakes are released by pushing in the red knob, leaving the tractor parking brakes applied. Air pressure in the primary or secondary reservoir must be at least 65 psi (447 kPa) before the tractor spring parking The red octagonal-shaped knob ( Fig. 6.3 ) in the con- trol panel actuates the trailer air supply valve.

After the vehicle’s air hoses are connected to a trailer, and the pressure in both air systems is at least 65 psi (448 kPa), the red knob must be pushed in. It should stay in, to charge the trailer air supply system and to release the trailer spring parking brakes; it must be pulled out before disconnecting a trailer. It must also 6.3