Steering and Brake Systems brakes, or the trailer service or spring parking brakes, can be released. hind the passenger seat. The ECU interprets the speed sensor signals and compares wheel speed, wheel braking and vehicle speed. If it senses wheel lockup, the ECU signals the appropriate solenoid control valve to reduce braking. During emergency braking, the solenoid control valve constantly adjusts air pressure supply in the brake chambers to prevent wheel lockup. On trailers not equipped with spring parking brakes, chock the trailer tires before disconnecting the truck or tractor when parking just the trailer.
When parking a truck or tractor with a trailer (combi- nation vehicle), and the trailer is not equipped with spring parking brakes, apply the truck or tractor spring parking brakes. CAUTION WARNING An accumulation of road salt, dirt, or debris on the ABS tone wheels and sensors can cause the ABS warning light to come on. If the ABS light does come on, the tone rings and sensors should be inspected for corrosion and serviced if necessary. The service should include cleaning of the tone rings and sensors. If any tone ring on a vehicle shows severe corrosion, all tone rings on that vehicle should be replaced.
If a trailer is not equipped with spring parking brakes, do not park it or a combination vehicle by pulling out only the trailer air supply valve knob. This would apply only the trailer service brakes. If air were to bleed from the trailer brake system, the trailer brakes would release, possibly causing an unattended runaway vehicle. During winter months in areas where corrosive materials are used on the highways, periodically clean the underside of the vehicle, including the tone rings and sensors, to ensure proper ABS function and to protect the components from cor- rosion. Clean more frequently when unusually corrosive chemicals are being used.
CAUTION Never apply the service and spring parking brakes simultaneously. To do so transmits exces- sive input force to the brake components, which could damage or cause eventual failure of brake actuating components. The electronic control unit also has a safety circuit that constantly monitors the wheel sensors, solenoid control valves, and the electrical circuitry. If only the tractor is equipped with an ABS system, the tractor warning light (TRAC ABS) comes on after the engine is started. See Fig. 6.4 . If all of the tractor’s ABS components are working, the light should go out when the vehicle moves faster than about 4 mph (6 km/h).
Meritor WABCO ® Antilock Braking System (ABS) The Meritor WABCO Antilock Braking System (ABS) is an electronic wheel speed monitoring and control system that works with the standard air brake sys- tem. ABS passively monitors vehicle wheel speed at all times, but controls wheel speed during an emer- gency or reduced-traction stop. In normal braking applications, the standard air brake system is in ef- fect. If equipped with the tractor and trailer ABS system, the vehicle also has a trailer warning light labelled TRLR ABS ( Fig. 6.4 ). IMPORTANT: For proper ABS system operation, do not change tire sizes.
The sizes of the tires installed during production are programmed into the electronic control unit. Installing different sized tires could result in a reduced braking force, leading to longer stopping distances. After the engine is started, the TRLR ABS light comes on if the trailer is equipped with a compatible ABS system. Once the vehicle moves faster than about 4 mph (6 km/h), the TRLR ABS warning light goes out only if all of the trailer’s ABS components are working. ABS includes signal-generating tone wheels and sen- sors located in the wheel hubs of each sensed axle.
The sensors transmit vehicle wheel speed informa- tion to an electronic control unit (ECU) located be- For more information on trailer ABS lamp operation, see Trailer ABS Lamp Operation in this chapter. A wheel spin indicator light (WHL SPIN) comes on if one of the drive wheels spins during acceleration 6.4