Freightliner FLD Conventional — FLD Conventional

Steering and Brake Systems ATC function switch must be in the NORMAL position when the vehicle is initially powered up. Once the vehicle is started, the ATC function switch can be set to the DEEP SNOW/MUD position. The ECU indi- cates this change by a constant flashing of the WHL SPIN lamp (or by illumination of the DEEP SNOW/ MUD light ( Fig. 6.4 ) on vehicles built before July, 1994). 1 2 3 If the ATC function switch is in the DEEP SNOW/ MUD position when the vehicle is powered up, the ECU will not accept this function change and will re- main in the NORMAL mode.

Indication of this condi- tion will be the absence of the flashing WHL SPIN light (on vehicles built before July, 1994, the absence of an illuminated DEEP SNOW/MUD light). To en- gage the DEEP SNOW/MUD mode in this situation, change the position of the ATC function switch to the NORMAL mode. After 2 seconds, move the switch to the DEEP SNOW/MUD position. When this occurs, the indicator light will activate as previously de- scribed. 4 05/31/95 f600771a 1. Parking Brake Indicator Light 2. Tractor ABS Warning Light 3. Wheel Spin Indicator Light 4. Trailer ABS Warning Light Fig. 6.4, Warning and Indicator Lights ( Fig. 6.4 ). The light goes out when the wheel stops spinning.

When the light comes on, partially release the throttle pedal until the light goes out. If slippery road conditions continue, engage the axle lock. IMPORTANT: ABS and ATC blink code diagnos- tics should only be performed when the vehicle is stopped. If the vehicle is equipped with ATC, turning "On" the ABS CHK switch will reduce engine speed to idle for 3 seconds and affect ATC function performance. If the vehicle is driven with the ABS CHK switch "On" (in the "Up" position), the WHL SPIN light will illuminate continuously.

Under this condition, turning the ABS CHK switch "Off" (in the "Down" position), while the vehicle is still in motion, will only turn off the WHL SPIN light, but will not restore ATC function performance. To fully restore engine and ATC function capability, the vehicle must be brought to a complete stop. Then, move the ABS CHK switch to "Off" (in the "Down" posi- tion). CAUTION Do not engage the axle lock while the WHL SPIN light is on. To do so could damage the rear axle. See Chapter 9 , "Rear Axles," for axle lock in- structions. If the vehicle is equipped with an electronic engine, an automatic traction control (ATC) system may be installed.

On these vehicles, the ATC system auto- matically reduces wheel spin during reduced-traction starts. An "ATC Function" switch (if equipped), allows the driver to select from two levels of drive axle traction- control assistance: The Meritor WABCO ABS system combines one front-axle control channel with either one rear axle (the 4-channel system), or two rear axles (the 6-channel system) to form one control circuit. For example, the sensor and solenoid control valve at the left-front axle form a control circuit with the sen- sor(s) and solenoid control valve(s) on the right rear axle(s).

If, during vehicle operation, the safety circuit senses a failure in any part of the ABS system (a sensor, solenoid control valve, wiring connection, short circuit, etc.), the tractor warning light (TRAC NORMAL—reduces drive axle wheel spin on icy, wet, or sand covered roads. DEEP SNOW/MUD—allows a higher threshold of drive axle wheel spin to help burn through a thin layer of ice, or to help throw off accumu- lated mud or snow. The DEEP SNOW/MUD mode is indicated by a flashing WHL SPIN light. To engage this mode, the 6.5