Steering and Brake Systems ABS) comes on and the control circuit where the fail- ure occurred is switched to normal braking action. The remaining control circuit will retain the ABS ef- fect. Even if the ABS system is partially or completely inoperative, normal braking ability is maintained. The vehicle is not disabled. when the ignition key is turned to the ON posi- tion, it is possible that the lamp is burned out. Automatic Slack Adjusters IMPORTANT: If any of the ABS warning lights do not work as described above, or come on while driving, repair the ABS system immedi- ately to ensure full antilock braking capability.
Automatic slack adjusters are required on all vehicles equipped with air brakes manufactured after October 20, 1994. Automatic slack adjusters should never be manually adjusted except during routine maintenance of the foundation brakes (e.g., replacing shoes), dur- ing slack adjuster installation or in an emergency situation. During emergency or reduced-traction stops, fully depress the brake pedal until the vehicle comes to a safe stop; do not pumpthe brake pedal. With the brake pedal fully depressed, the ABS system will control all wheels to provide steering control and a reduced braking distance.
When the brake pushrod stroke exceeds the legal brake adjustment limit on a vehicle, there is likely a mechanical problem with the foundation brake com- ponents or the adjuster is improperly installed. Visit a repair facility as soon as possible when brakes equipped with automatic slack adjusters are determined to be out of adjustment. Although the ABS system improves vehicle control during emergency braking situations, the driver still has the responsibility to drive appropriately for exist- ing traffic and road conditions. For example, the ABS system cannot prevent an accident if the driver is speeding or following too closely on slippery road surfaces.
WARNING Manually adjusting an automatic slack adjuster to bring the pushrod stroke within legal limits is likely masking a mechanical problem. Adjustment is not repairing. In fact, continual adjustment of automatic slack adjusters may result in prema- ture wear of the adjuster itself. Further, the im- proper adjustment of some automatic slack ad- justers may cause internal damage to the adjuster, thereby preventing it from properly functioning. Trailer ABS Lamp Operation Antilock braking systems on tractors are designed to communicate with trailer ABS systems, if they are compatible.
Compatibility will result in the illumination of the trailer ABS lamp during vehicle start-up and fault detection. The dash-mounted lamp will operate as follows when a compatible trailer is properly connected to a tractor: When the ignition key is turned to the ON posi- tion, the trailer ABS lamp will illuminate mo- mentarily, then turn off. If the lamp comes on momentarily during ve- hicle operation, then shuts off, a fault was de- tected and corrected. If the lamp comes on and stays on during ve- hicle operation, there is a fault with the trailer ABS. Repair the trailer ABS system immedi- ately to ensure full antilock braking capability.
The Trailer ABS lamp will not illuminate unless a compatible trailer is connected to the tractor. IMPORTANT: If a compatible trailer is connected and the lamp is not illuminating momentarily 6.6