Freightliner FLD Conventional — FLD Conventional

Engines and Clutches EPA07 Aftertreatment System (ATS) extra fuel is injected into the exhaust stream to su- perheat the soot trapped in the DPF and turn it to ash. Active regeneration happens only when the ve- hicle is moving above a certain speed, determined by the engine manufacturer. Consult manufacturers’ documentation for details. All on-road diesel engines built after December 31, 2006 (EPA07 engines) must meet strict new guide- lines for reduced emissions of particulate matter and nitrogen oxides (NOx) from the exhaust. NOx is lim- ited to just over 1 gram per brake horsepower hour (g/bhp-hr) and particulate matter cannot exceed 0.01 g/bhp-hr.

Both active and passive regeneration happen auto- matically, without driver input. NOTE: Caterpillar engines do not use a DOC; Cat engines burn diesel fuel at the regeneration head to superheat the exhaust and burn the trapped soot to ash. Engine software monitors and controls this process. EPA07-compliant engines require ultralow-sulfur die- sel (ULSD) fuel, and they should never be run on fuel with sulfur content higher than 15 ppm. In addi- tion, they require low-ash engine oil. The following guidelines must be followed or the warranty may be compromised. If conditions do not provide for at-speed active re- generation, the vehicle will need a driver-activated parked regeneration .

The vehicle must be standing still, and the driver must initiate parked regen. Com- pleting a parked regen takes 20 minutes to an hour, depending on ambient conditions. Use ultralow-sulfur diesel (ULSD) with 15 ppm sulfur content or less, based on ASTM D2622 test procedure. Do not use fuel blended with used engine lube oil or kerosene. DANGER Engine lube oil must have a sulfated ash level less than 1.0 wt %; currently referred to as CJ-4 oil. During parked regeneration, exhaust tempera- tures are very high, and could cause a fire, heat damage to objects or materials, or personal in- jury to persons near the exhaust outlet.

The "exhaust system" in EPA07-compliant vehicles is called the aftertreatment system (ATS). The ATS var- ies according to engine manufacturer and vehicle configuration, but instead of a muffler, an aftertreat- ment system has a device that outwardly resembles a muffler, called the aftertreatment device (ATD). Before initiating a parked regeneration, make cer- tain the exhaust outlets are directed away from structures, trees, vegetation, flammable materi- als, and anything else that may be damaged or injured by prolonged exposure to high heat. IMPORTANT: See your engine operation manual for complete details and operation of the after- treatment system.

There are three warning lamps in the driver message center that alert the driver of the need to perform a parked regen, clean the filter, or of an engine fault that affects the emissions. Inside the ATD on Mercedes-Benz, Detroit Diesel, and Cummins engines, the exhaust first passes over the diesel oxidation catalyst (DOC), then it passes through the diesel particulate filter (DPF), which traps soot particles. If exhaust temperature is high enough, the trapped soot is reduced to ash, in a process called passive regeneration (regen). Passive regen- eration occurs as the vehicle is driven normally under load; the driver is not even aware that it is happening.

The harder an EPA07 engine works, the better it disposes of soot, as the exhaust heat alone is enough to burn the soot to ash. Over the course of a workday, however, passive regeneration cannot always keep the ATD filter clean, so the filter must undergo active regeneration . In active regeneration, A slow (10-second) flash of the high exhaust system temperature (HEST) lamp, indicates a regeneration is in progress, and the driver is not controlling the en- gine idle speed. A solid illuminated high exhaust system temperature (HEST) lamp, alerts the operator of high exhaust temperature during the regeneration process, when the speed is below 5 mph (8 km/h).

The HEST lamp does not signify the need for any kind of vehicle or engine service; it only alerts the vehicle operator of high exhaust temperatures. Make sure the engine exhaust pipe outlet is not directed at any person, or 7.1