1 page 1 Models J08C-TP and J08C-TR ENGINE 3-9-23 3. Tighten the connecting rod nut in the order as shown in the figure to the specified torque below. Tightening torque: 700 kg·cm (51 lb·ft) 4. Mark the cap nut with paint to indicate the same di- rection. 5. Tighten the cap nut 90° (1/4 turn) in the same order as in step 3. 6. Tighten the cap nut 45° (1/8) turn as in step 5. 7. Make sure that all paint marks face the same direc- tion. NOTE: When adding torque, never untighten the nuts, even it they have been overtightened. PAINT MARK SM3-J249 Fig. 84 12. MEASURE THE CONNECTING ROD END PLAY. Measure the clearance between the connecting rod and crankpin end surface using a dial gauge.
If the value ex- ceeds the limit, replace the connecting rod. Standard: 0.20 - 0.53 mm (0.0079 - 0.0208 in.) Limit: 0.5 mm (0.0197 in.) SM3-J701 Fig. 85