1 page 1 Models J08C-TP and J08C-TR 3-9-22 ENGINE NOTE: G Before installation, apply engine oil to the piston pin, piston ring, cylinder liner and connecting rod bear- ing. G Recheck the matching point of each piston ring. G Make sure that the 0-mark on the piston is at the ex- haust side. COOLING JET Fig. 80 SM3-J246 EXHAUST PORT SIDE “O” MARK NOTE: When inserting the piston, be careful that the cooling jet is not struck by the connecting rod. If struck, make sure you recheck the sight of the cooling jet. SM3-J247 INTAKE PORT SIDE Fig. 81 11. INSTALL THE CONNECTING ROD CAP. SM3-J700 Fig. 82 1. Measure the length of the bolts, if the length is A or more, replace with new bolts.
A = 83.5 mm (3.2874 in.) 2. Apply clean engine oil to the nut seat surface and bolt thread of the connecting rod cap. A SM3-J248 Fig. 83