1 page 1 Models J08C-TP and J08C-TR ENGINE 3-9-21 8. ASSEMBLE THE PISTON RING. 1. Facing the identification marks on the piston ring upper surface, install in the order of oil ring (4N), second ring (2N) and top ring (1N) using the special tool. Special tool: Piston ring expander (09442 - 1011) NOTE: RING UPPER FACE IDENTIFICA- TION MARK TOP RING HARD CHROME PLATING HARD CHROME PLATING SECOND RING OIL RING HARD CHROME PLATING G Never change the combination of the coil and oil ring. G Connect the joint of the coil expander for the oil ring and install it inside the piston ring. Assemble the ring with the joint 180° opposite to the matching point of the ring. JOINT HARD CHROME PLATING GAP Fig.
76 ASM3-J244 2ND RING sition the matching points of the piston ring at an even distance without the piston boss and thrust direction. O-MARK OIL RING TOP RING Fig. 77 SM3-J245 9. ASSEMBLE THE CONNECTING ROD BEARING. NOTE: G When reusing the bearing, make sure you reassem- ble the removed bearing as it was originally installed. G Install the bearing with the oil hole on the connecting rod side and the bearing without the oil hole on the cap side. G Match the bearing protrusion with the notch of the connecting rod or cap. Fig. 78 SM3-J698 10. INSTALL THE PISTON THROUGH THE CONNECTING ROD ASSEMBLY ONTO THE CYLINDER BLOCK. 1.
Insert the piston through the connecting rod assem- bly into the cylinder block using the special tool and a hammer handle. Special tool: Piston ring holder (09441 - 1320) SM3-J699 Fig. 79