Hino J08C-TP, J08C-TR — PISTON, CRANKSHAFT AND CYLINDER BLOCK

1 page 1 Models J08C-TP and J08C-TR 3-9-20 ENGINE 7. ASSEMBLE THE PISTON WITH THE CONNECTING ROD. 1. Install a new retainer ring onto one end of the piston boss. NOTE: Installing the retainer ring may cause it to fly up. Be sure to wear protective goggles. 2. Immerse the piston in hot water, 80 - 90°C (176 - 194°F) for approximately five minutes. 3. Assemble the piston O-mark to be opposite the con- necting rod alignment mark. SM3-J697 Fig. 74 PISTON “O” MARK WARNING Never touch the piston when it is hot with your bare hands. EXHAUST PORT SIDE INTAKE PORT SIDE OIL HOLE 4. Insert the piston pin into the piston. NOTE: MATCH MARKS G Never touch the piston when it is hot with your bare hands.

G Insert the piston pin from the piston boss attached to the retainer ring so that the ring groove is not dam- aged. 5. Install a new retainer ring to the other end of the pis- ton boss. SM3-J234 Fig. 75 WARNING Installing the retainer ring may cause it to fly up. Be sure to wear protective goggles. NOTE: G When using an oversize piston, hone so that clear- ance between the cylinder liner and the piston is the standard value. G Prevent parts from damage by wrapping them in a cloth while they are being installed onto the cylinder block. G Measure the entire length of the connecting rod bolt. (Refer to page 3-9-22.)