1 page 1 Models J08C-TP and J08C-TR ENGINE 3-9-19 a. Measure the length of the bearing cap bolts, if the length is A or more, replace with new bolts. A = 108 mm (4.2520 in.) b. Apply clean engine oil to the bolt seat and bolt threads. A SM3-J236 Fig. 69 c. Tighten the bolts in the order as shown in the figure to the specified torque below. Tightening torque for preload: 700 kg·cm (51 lb·ft) d. Loosen all bolts. e. Tighten the bolts as in step c. Tightening torque for preload: 700 kg·cm (51 lb·ft) w r y i !0 !2 !4 FRONT q e t u o !1 !3 SM3-J280 Fig. 70 f . Mark the bolts with paint to indicate the same direc- tion. g. Tighten the bolts 90° (1/4 turn) in the same order as in step c. h.
Finally, retighten the bolts 45° (1/8 turn) as in step g. i. Make sure that all paint marks face the same direc- tion. NOTE: When adding torque, never untighten the nuts, even it they have been overtightened. j. After tightening, tap the front and back ends of the crankshaft using a plastic-faced hammer to allow complete fit. PAINT MARK 90° 45° SM3-J238 Fig. 71 5. MEASURE THE CRANKSHAFT END PLAY. Measure the crankshaft end play using a dial gauge. If the value exceeds the limit, replace the thrust bearing with the oversize one of 0.25 mm (0.0098 in.). Standard: 0.050 - 0.219 mm (0.0020 - 0.0086 in.) Limit: 0.50 mm (0.0196 in.) SM3-J695 Fig. 72 6. CHECK THE PISTON.
Before assembling the piston with the connecting rod, check whether the piston is specified for this engine. NOTE: Check using the engine compatible identification code on the top of the piston. Engine compatible identification code: 72 PISTON IDENTIFICATION SYMBOL 72 TOP VIEW SM3-J696 Fig. 73