Hino J08C-TP, J08C-TR — PISTON, CRANKSHAFT AND CYLINDER BLOCK

1 page 1 Models J08C-TP and J08C-TR 3-9-18 ENGINE Standard: 0.01 - 0.08 mm (0.0004 - 0.0031 in.) Limit: 0.08 mm (0.0031 in.) PRESSURE: 500 kg (1,100 lb) PROTRUSION SM3-J250A Fig. 65 3. INSTALL THE CRANKSHAFT. 1. Install the main bearings onto the cylinder block and main bearing caps. NOTE: G When reusing a bearing, make sure you reassemble the removed bearing as it was originally installed. G Install the bearing with the oil hole on the block side and the bearing without the oil hole on the cap side. G Match the bearing protrusion with the notch of the block or cap. G After installation, apply engine oil to the journal sur- faces of the bearings. SM3-J551 Fig. 66 2.

Install the crankshaft onto the cylinder block. SM3-J682 Fig. 67 3. Install the thrust bearings onto the four points of the No. 4 journal of the cylinder block and either side of the main bearing caps. NOTE: G When reusing a bearing, make sure you reassemble the removed bearing as it was originally installed. G Install the thrust bearing with the groove side (front) toward the crankarm and with the part number stamp (back) toward the main bearing cap or cylinder block. G Apply engine oil or grease to the back of the bearing to prevent loosening during installation. G Fit the bearing to the mounting groove of the block and cap side. 4. Install the main bearing cap. NOTE:

Facing the arrow stamped on the cap forward, install in the order of stamped numbers. SM3-J235 Fig. 68