Hino J08C-TP, J08C-TR — PISTON, CRANKSHAFT AND CYLINDER BLOCK

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-9-17 MOUNTING 1. ASSEMBLE THE CYLINDER LINER. NOTE: ENGINE NUMBER MARKS OF LINER G When assembling the cylinder liner with the cylinder block, clearance can be set to three levels. G When using a new cylinder liner, the upper surface and side surface of the cylinder block are stamped A, B or C. Insert a matching cylinder liner having the same symbol. SM3-J231A FRONT Fig. 60 CYLINDER LINER LINER IDENTIFICATION MARK SM3-J232 Fig. 61 1. Insert a cylinder liner into the cylinder block using the special tool. Special tool: Guide (09471 - 1490) NOTE: G Handle the cylinder liner carefully because it is thin. If it falls on the floor, it cannot be used.

G Install the cylinder liner after engine oil has been applied to the inner surface of the cylinder block bore. SM3-J692 Fig. 62 G When reusing a cylinder liner, install it according to the alignment marks made during removal. The cyl- inder liner is bent by “run-in”. When reusing the cyl- inder liner, misalignment with the cylinder block may concentrate stress on the thin part of the cylinder liner and it may break. MATCH MARKS SM3-J693 Fig. 63 2. MEASURE THE PROTRUSION AT THE CYLINDER LINER. 1. Install the special tool onto the cylinder block. Special tool: Cylinder liner puller (09420 - 1720) 2.

Tighten the center bolt to the specified torque below to set the cylinder liner in the normal installation con- dition. Tightening torque: 100 kg·cm (7.23 lb·ft) 3. Measure the protrusion at the cylinder liner using the dial gauge. If the value exceeds the limit, replace the cylinder liner. SM3-J233 Fig. 64