Hino J08C-TP, J08C-TR — PISTON, CRANKSHAFT AND CYLINDER BLOCK

1 page 1 Models J08C-TP and J08C-TR 3-9-16 ENGINE 4. Start the oil pump, let the engine oil spray out the cooling jet nozzle to check that the center of the jet flow is within the 7 mm ( 0.27 in.) reference line of the gauge as well as to judge whether the jet flow is good based on the figure. NOTE: Use new engine oil. SPRAY TARGET ABNORMAL ABNORMAL NORMAL NORMAL WARNING Engine oil is flammable. This spray test should be done in a well ventilated room and away from any open flames or electric sparks. Fig. 56 SM3-J161 SPRAY PATTERN SPRAY COOLING JET 1 2 3 4 ABNORMAL SM3-J549 Fig. 57 7.

If the center of the jet flow is out of the 7 mm ( 0.27 in.) reference line of the gauge, adjust the nozzle sight using the special tool. Special tool: Adjusting bar (09672 - 1620) 8. Remove the checking bolt after inspection, install the cooling jet onto the cylinder block using the cooling jet checking bolt. NOTE: SM3-J550 G Always install the soft washer. G When installing the piston, make sure that the cool- ing jet is not struck by the piston when at bottom dead center. Fig. 58 INSPECT THE ENCLOSURE COVER. Check the sound insulator for damage or wear visu- ally. If there is any damage or wear, replace the parts with new ones. Fig. 59 SM3-J277B