1 page 1 Models J08C-TP and J08C-TR ENGINE 3-9-15 NOTE: Machined dimension of fillet “R” Crank pin: 5.0 - 5.5 mm (0.1968 - 0.2165 in.) Crank journal: 5.0 - 5.5 mm (0.1968 - 0.2165 in.) R WRONG CORRECT SM3-J234 Fig. 51 CYLINDER BLOCK MAIN BODY 1. Remove the water gallery plug, and check the condi- tion of the worm hole visually. If the wear is exces- sive, replace the part with a new one. Also inspect inside the cylinder block, and clean the cylinder block main body with a commercial cleaning agent as re- quired. NOTE: Refer to page 3-9-4. 2. Check the cylinder block for cracks. Check the cylinder block for cracks using the dye penetrant test.
If any are found, replace the cylinder block with a new one. 3. Check the flatness of the cylinder block upper sur- face. Check the flatness of the cylinder block upper sur- face in the direction as shown in the figure using a straight edge and feeler gauge. If the value exceeds the limit, replace the cylinder block with a new one. Flatness of the cylinder block upper surface: Standard: 0.05 mm (0.0020 in.) or less Limit: 0.20 mm (0.0079 in.) INSPECT AND ADJUST THE COOLING JET. 1. After removing the cooling jet checking bolt, reinstall the cooling jet on the cylinder block using the spe- cial tool. Special tool: Checking bolt (9001 - 24262) 2.
Connect a commercial oil pump (hydraulic pressure: 2 kg/cm 2 (28 lb/sq.in.)) to the special tool using a hose. SM3-J548 Fig. 52 B C D A E F G SM3-J505 Fig. 53 COOLING JET SPECIAL TOOL OIL HOSE Fig. 54 SM3-J159 SPECIAL TOOL 3. Set the special tool on the cylinder block upper sur- face against the dowel pin. Special tool: Gauge (09444 - 1630) CYLINDER BLOCK Fig. 55 SM3-J421