Hino J08C-TP, J08C-TR — PISTON, CRANKSHAFT AND CYLINDER BLOCK

1 page 1 Models J08C-TP and J08C-TR 3-9-14 ENGINE MEASURE THE CLEARANCE BETWEEN THE CRANK JOURNAL AND THE MAIN BEARING. 1. Measure the crank journal outside diameter using a micrometer. If the value exceeds the limit for repair, grind the crank journal to correct. If the value exceeds the limit for use, replace the crankshaft with a new one. Standard: 80 mm (3.1496 in.) Limit for repair: 79.80 mm (3.1417 in.) Limit for use: 78.80 mm (3.1024 in.) SM3-J690 Fig. 46 Y X X' Y' SM3-J529 Fig. 47 2. After installing and tightening the main bearing caps, measure the main bearing inside diameter using a cylinder gauge. If the value exceeds the limit, replace the main bearing with a new one. Standard:

80 mm (3.1496 in.) Limit: 0.3 mm (0.0118 in.) NOTE: G When installing the main bearing caps, make sure to return them to the original position with reference to the number stamped on the caps. The main bearing caps together with the cylinder block are profiled by roundness. G For tightening of the main bearing cap, refer to page 3-9-18. Fig. 48 SM3-J689 XY Z 3. Calculate the clearance between the crank journal and the main bearing. If the value exceeds the limit, grind the crank journal to the specified undersize below to correct. Replace the main bearing with a correct one. Standard: 0.051 - 0.102 mm (0.0020 - 0.0040 in.) Limit: 0.20 mm (0.0079 in.) Undersize machining dimension:

Two sizes below. 0.25 mm (0.0098 in.), 0.50 mm (0.0197 in.) NOTE: Make sure you replace the top and bottom main bearings as one set. The top and bottom main bearings must be profiled by roundness. Fig. 49 SM3-J547 Fig. 50 Under size Outside diameter Pin Journal STD 64.940 - 64.960 79.940 - 79.960 0.25US 64.690 - 64.710 79.690 - 79.710 0.50US 64.440 - 64.460 79.440 - 79.460