1 page 1 Models J08C-TP and J08C-TR ENGINE 3-9-13 INSPECT THE CRANKSHAFT. NOTE: Before inspection, clean the crankshaft with a commercial cleaning agent and clean the lubri- cation passage using an air gun. 1. Check the crankshaft for cracks using the dye pen- etrant test. If any are found, replace the crankshaft with a new one. NOTE: Pay special attention to the finished R section and oil hole of the crank journal and crankpin. SM3-J261 Fig. 41 2. Check the condition of the crank journal and crank- pin visually for damage or wear. Grind the crank jour- nal and crankpin to correct as required, or replace the crankshaft with a new one. SM3-J262 Fig. 42 3.
Support both end journals of the crankshaft with V blocks and measure the deflection of the crankshaft at the center journal using a dial gauge. If the value exceeds the limit, replace the crankshaft with a new one. Limit: 0.15 mm (0.0059 in.) Fig. 43 SM3-J688 MEASURE THE ROUNDNESS OF THE MAIN BEARING CAPS After tightening the main bearing caps, measure the in- side diameter of the main bearing caps using a cylinder gauge to calculate the roundness. If the value exceeds the limit, carry out boring after overlay welding or replace the cylinder block with a new one. Standard: 85 mm (3.3465 in.) Limit: 0.06 mm (0.0024 in.) NOTE: Fig.
44 SM3-J689 G When installing the main bearing caps, make sure to return them to the original position with reference to the number stamped on the caps. The main bearing caps together with the cylinder block are profiled by roundness. G For tightening of the main bearing caps, refer to page 3-9-18. XY Z Fig. 45 SM3-J547