Models J08C-TP and J08C-TR ENGINE 3-10-5 1 page 1 2. Measure the inside diameter of driven gear bushing using a cylinder gauge. 3. Calculate the clearance between the driven gear shaft and the driven gear bushing. If the value exceeds the limit, replace the idler gear shaft or oil pump assembly with a new one. Standard: 0.040 - 0.083 mm (0.0016 - 0.0032 in.) Limit: 0.15 mm (0.0059 in.) SM3-J704 Fig. 7 OIL PUMP SAFETY VALVE DISASSEMBLING 1. Remove the cotter pin and then remove Seat 2, Seat 1, the relief valve spring and the safety valve. WARNING Removing the cotter pin may cause Seat 2 and the relief valve spring to spring out. Be sure to wear protective goggles. SM44-0033 Fig.
8 INSPECTION AND REPAIR NOTE: Before inspection, be sure to clean metal parts using treated oil. 1. Inspect each part for damage or wear visually. If damage or wear is excessive, replace the safety valve with a new one. 2. If the spring is flattened, replace the safety valve with a new one. SM3-J553A Fig. 9 ASSEMBLING 1. Attach the safety valve, the relief valve, Seat 1 and Seat 2 onto the oil pump cover assembly using the cotter pin. WARNING When assembling, the spring and the spring seal may spring out. Be sure to wear protective goggles. Fig. 10 SM3-J705B