Hino J08C-TP, J08C-TR — COOLING SYSTEM

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-11-5 3. Remove the retainer ring from the pump case using snap ring pliers. SM3-J710 Fig. 13 4. Push the shaft from the vane side using a hydraulic press, and remove the bearing, collar and shaft from the pump case. NOTE: G Before pressing, recheck that the retainer ring is re- moved completely. G Replace the removed bearing with a new one. Never reuse it. SM3-J711 Fig. 14 5. Remove the coolant seal from the pump case using a hammer and brass bar. WARNING Impact due to punching may cause metal chips to fly up. Be sure to wear protective goggles. NOTE: Replace the removed coolant seal with a new one. Never reuse it. SM3-J712 Fig.

15 INSPECTION AND REPAIR INSPECT THE VANE. Check the vane for corroded or damaged condition visu- ally. If it is defective, replace the vane with a new one. NOTE: Pay special attention to the vane blade during inspections. INSPECT THE PUMP CASE. Check the vane side of the coolant seal mount and bear- ing mount on the pump case for corrosion, wear or dam- age visually. If defective, replace the pump case with a new one. INSPECT THE SHAFT. Check the threads and bearing inner race mount of the shaft for wear or damage visually. If defective, replace the shaft with a new one.