1 page 1 Models J08C-TP and J08C-TR 3-11-6 ENGINE ASSEMBLING 1. Install the bearing collar and shaft onto the pump case using a hydraulic press. NOTE: G Make sure you use a new bearing. G Press until the bearing upper end surface comes into contact with the retainer ring groove lower end sur- face. SM3-J714 Fig. 16 2. Install the retainer ring onto the pump case using snap ring pliers. SM3-J715 Fig. 17 3. Install the pulley center onto the shaft using a hy- draulic press. Standard: 129.0 - 129.8 mm (5.0788 - 5.1102 in.) from the pulley center mounting surface to the pump case end surface SM3-J716 Fig. 18 4. Install the new coolant seal. a.
Apply a little sealer to the coolant seal outer circum- ference and coolant pump body. b. Install the slinger and coolant seal. NOTE: Replace the coolant seal with a new one. SM3-J793 Fig. 19 c. Install the coolant seal to the vane. NOTE: Replace the coolant seal with a new one. Fig. 20 SM3-J794