1 page 1 Models J08C-TP and J08C-TR 3-12-6 ENGINE ASSEMBLING 1. Assemble the pressure pin and nozzle spring onto the nozzle holder upper part. 2. Mount the nozzle holder in a vise, assemble the noz- zle assembly onto the nozzle holder lower part, and tighten the retaining nut to the specified torque be- low. Tightening torque: 650 kg·cm (47 lb·ft) NOTE: SM3-J556 Fig. 11 G When assembling the nozzle holder, take care to pre- vent adherence of dust or dirt. Always be sure to clean the work place and tools. G Take care not to drop the nozzle assembly, which may cause damage. CHECK THE INJECTION OPENING PRESSURE.
Operate the lever at the rate of 15 to 16 strokes per minute using a nozzle hand tester to read the injection start pres- sure. If the injection opening pressure is out of the stand- ard value, adjust the injection opening pressure. Injection opening pressure: 220 kg/cm 2 (3,129 lb/sq. in.) SM3-J726 Fig. 12 WARNING G Since diesel oil is flammable, check and adjust the nozzle in a well ventilated room. Never use naked lights in the room. G Since injected fuel is highly pressurized, direct contact with the body may be harmful to health. Provide a screen to prevent scattering of fuel. ADJUST THE INJECTION OPENING PRESSURE.
Turn and adjust the adjusting screw so that the opening valve pressure is within the standard value using the noz- zle hand tester. Injection opening pressure: 220 kg/cm 2 (3,129 lb/sq. in.) NOTE: Tightening the adjusting screw..... increases pres- sure. Loosening the adjusting screw..... decreases pres- sure. COARSE GOOD COARSE COARSE Fig. 13 SM3-J182A INSPECT THE SPRAY PROFILE. Inspect the spray profile using a nozzle hand tester. If the spray is coarse, inspect it again after cleaning. If it is still coarse, replace the nozzle assembly with a new one. NOTE:
In the case of a new nozzle, operate the lever at the rate of 30 to 60 strokes per minute, and for a used nozzle, operate the lever at the rate of 15 to 16 strokes per minute. Fig. 14 SM3-J557A