Hino J08C-TP, J08C-TR — FUEL SYSTEM

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-12-7 TEST THE FUEL LEAKAGE. When checking for fuel leakage from the nozzle, apply a pressure about 10 - 20 kg /cm 2 (142 - 284 lb/sq.in.) lower than the correct injection pressure to the nozzle using a nozzle hand tester. If defective, test it again after cleaning. If still defective, replace the nozzle assembly with a new one. AIR BLEEDING FROM FUEL SYSTEM 1. Loosen the bleeder plug on the fuel filter. 2. Turn the priming pump counterclockwise to come to the surface, then move it up and down. 3. Operate the priming pump until fuel, without bubbles, comes out of the bleeder plug. SM3-J744 Fig. 15 4. Tighten the bleeder plug. 5.

Move the priming pump up and down 5 to 6 times again. 6. Tighten the priming pump clockwise completely while it is pushed back. NOTE: Wipe up any splashed fuel after finishing the work, and recheck that there is no fuel leakage after engine start-up. INSTALLATION OF COMPONENT PARTS INSTALL THE INJECTION PUMP. NOTE: Refer to page 3-17-5. INSTALL THE INJECTION NOZZLE. NOTE: Refer to page 3-6-23.