1 page 1 Models J08C-TP and J08C-TR 3-13-6 ENGINE 3. INSPECT THE UNLOADER VALVE. Check to see if the unloader valve is damaged or miss- ing, water and dirt will get into the filter and damage the element. SM3-J558 Fig. 6 4. CLEAN THE ELEMENT ACCORDING TO ONE OF THE FOLLOWING METHODS, DEPENDING ON THE DE- GREE TO WHICH IT IS SOILED. 1. When the element is fouled by dry dust. Remove dust by blowing dry compressed air from the inside of the element towards the outside, then compressed air from the outside in the longitudinal direction of the filter. SM3-J559 Fig. 7 WARNING To prevent injury, always select appropriate type of safety glasses for the job. NOTE:
G When cleaning the element, do not strike, knock or drop it, as this will cause damage. G To prevent damaging the element, keep the air pres- sure below 7 kg/cm 2 (99.6 lb/sq.in). 2. When the element is fouled by soot or oil mist, wash the element thoroughly with 300 g (0.66 lb) of ele- ment detergent (Donaldson type ND-1500 or D-1400) dissolved in 5 liters (5.3 US.qts) of hot water diluted to 20 liters (21.1US.qts). NOTE: Never clean the element with gasoline, fuel oil, kerosene, or solutions containing any of these. Fig. 8 SM3-J732 a. Immerse the element in the solution for 30 minutes. Fig. 9 SM3-J560