1 page 1 Models J08C-TP and J08C-TR 3-14-4 ENGINE INSTALLATION AND ADJUSTMENT NOTE : Install the cables in the reverse sequence of re- moval, and be careful of the following points. 1. INSTALLATION OF ACCELERATOR CONTROL MECHANISM Both the accelerator cable and engine stop cable are taped in order to facilitate identification during installation. After being sure to connect the correct cable, successively clip the cables, ensuring that they do not sag. ENGINE STOP CABLE ACCELERATOR CABLE SM3-J736A Fig. 5 MARKING CLAMP POSITION NOTE:
Ensure that the bending radius of the cable is no less than 150 mm (5.91 in), otherwise the sliding resistance will become excessively high and ca- ble durability will also be adversely affected. Provide a suitable amount of slack in the cable between the engine and frame. This is because of the danger of the cable breaking due to rela- tive motion between the engine and frame. RADIATOR SM3-J737A Fig. 6 2. ADJUSTING THE ACCELERATOR CONTROL MECHA- NISM 1. Prior to fitting the throttle cable, turn the knob coun- ter-clockwise until it stops, then back off 4 turns from the position. SM3-J566 Fig. 7 2. Set the accelerator pedal at an angle of A˚ with re- spect to the floor surface.
Accelerator pedal angle (A˚) : 3. Eliminate slack in the cable of the control lever of the injection pump. 4. Adjust the stopper bolts so that the clearance be- tween the pedal and the stopper is 2 - 5 mm (0.079 - 0.196 in) 5. For the model equipped with a manual transmission ; confirm that the amount of force applied on the pedal (measured point P) is 4 kg (9 lb) at the initial stage [2 - 3 mm (0.079 - 0.11 in)] and 7 kg (15 lb) at full stroke. A SM3-J567 Fig. 8