Hino J08C-TP, J08C-TR — ENGINE CONTROL SYSTEM

1 page 1 ENGINE 3-14-3 Models J08C-TP and J08C-TR 3. ENGINE STOP MECHANISM 1. Set the engine starter key at ON position. WARNING Do not start the engine. NOTE : Slacking the engine stop inner cable by setting the engine starter key at ON position facilitate dis- mounting, mounting and adjustment of the cable. 2. Tilt the cab. 3. Make sure that the engine stop lever of the fuel in- jection pump is at engine running position as shown in Fig. 4, then disconnect the connectors of the en- gine stop motor harness. 4. Set the engine starter key at LOCK position. 5. Remove the pin from the engine stop lever, and dis- connect the cable. 6.

Remove the clip bands fixing the cable to the frame, then remove the cable. 7. Remove the engine stop motor. SM3-J580 Fig. 3 ACCELERATOR CABLE ENGINE STOP CABLE ADJUSTING NUT ENGINE STOP POSITION ENGINE RUNNING POSITION SM3-J565 Fig. 4 INSPECTION 1. CHECK THE PEDAL AND LINK LEVER. Inspect the accelerator pedal and link lever for damage, deformation and wear. 2. CHECK THE CABLES. 1. Check the throttle and accelerator cable for smooth movement, and also inspect these parts for damage and rust. WARNING If the sliding resistance of the accelerator cable in- creases, and the cable does not return promptly, panic braking performance will be adversely af- fected, which is extremely dangerous.

Replace the accelerator cable of which sliding resistance has once increased to such an extent. 2. Check the engine stop cable for smooth movement and inspect it for damage and rust.