Hino J08C-TP, J08C-TR — INSTALLATION OF THE ENGINE COMPONENT PARTS

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-17-1 INSTALLATION OF THE ENGINE COMPONENT PARTS 1. INSTALL THE COOLANT PUMP. 1. Clean the cylinder block mounting surface of cool- ant pump. 2. Apply liquid gasket to the coolant pump and install it onto the cylinder block within 20 minutes. Liquid gasket: ThreeBond No. 1207B Coating width: 1.5 - 2.5 mm (0.06 - 0.10 in.) NOTE: MATCHING FLANGE FACE WITH BLOCK MATCHING FLANGE SM3-J033 Fig. 1 G If more than 20 minutes have passed since the liquid gasket was applied, do not assemble. After removing the liquid gasket completely, reapply it to assemble. G Refer to page 3-20-1. 2. INSTALL THE THERMOSTAT CASE. 1.

Make sure that the O-ring is attached to the upper flange face of the coolant pump. 2. Clean the cylinder block mounting surface of the ther- mostat case. 3. Apply liquid gasket to the thermostat case and in- stall it onto the cylinder block within 20 minutes. Liquid gasket: ThreeBond No. 1207B Coating width: 1.5 - 2.5 mm (0.06 - 0.10 in.) NOTE: FACE WITH CYLINDER HEAD LIQUID GASKET Fig. 2 SM3-J036 G If more than 20 minutes have passed since the liquid gasket was applied, do not assemble. After removing the liquid gasket completely, reapply it to assemble. G Refer to page 3-20-1. 4. Attach the three upper bolts of the thermostat mount- ing bolts provisionally. 5.

Tighten the four side bolts of the thermostat case mounting bolts to the specified torque below. Tightening torque: 290 kg·cm (21 lb·ft) 6. Tighten the three upper bolts of the coolant pump mounting bolts to the specified torque below. Tightening torque: 560 kg·cm (41 lb·ft) 7. Install the cooling line. UPPER BOLT SIDE BOLT THERMOSTAT CASE O-RING COOLANT PUMP SM3-J750 Fig. 3