Hino J08C-TP, J08C-TR — ENGINE TUNEUP

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-18-1 ENGINE TUNEUP HOW TO GET THE TOP DEAD CENTER OF THE COM- PRESSION STROKE FOR NO.1 PISTON 1. Turn the crankshaft to align mark 1-6 on the outer periphery of the flywheel with the pointer of the fly- wheel housing. NOTE: In this position the No. 1 and No. 6 pistons are at the top dead center. Fig. 1 MATCHING MARK G Before installing the injection pump, the No. 1 pis- ton is at the top dead center of the compression stroke when the coupling mounting key of the air compressor is at the upper side. 48.5° KEY SM3-J002 Fig. 2 POINTER G After installing the injection pump, if the timer timing mark is nearly aligned with the pointer, the No.

1 pis- ton is at the top dead center of the compression stroke. NOTE: If not, turn the crankshaft one complete revo- lution and align marks as shown above. TIMING MARK Fig. 3 G The No.1 piston is at the top dead center of the com- pression stroke when the arrow printed on the cam- shaft points up and the underline is horizontal. Fig. 4 G The piston, whose intake and exhaust rollers both rotate easily when the roller of the rocker arm is moved with a finger, is at the top dead center of the compression stroke. INTAKE ROLLER EXHAUST ROLLER Fig. 5