1 page 1 Models J08C-TP and J08C-TR ENGINE 3-18-3 5. Loosen the adjusting screw nut of the cross head completely. NOTE: G The adjusting screw must protrude 10 mm (0.3937 in.) or more from the cross head up- per face. G Unless the adjusting screw is completely loose to the valve stem, the following adjust- ments may be adversely affected. Fig. 11 6. Insert a feeler gauge between the rocker arm and cross head. Adjust clearance with the adjusting screw of the rocker arm. Tighten the lock nut with the fol- lowing torque. Tightening torque : 250 kg·cm (18 lb·ft) NOTE: The feeling of the feeler gauge during clear- ance adjustment is the same as before. SM3-J813 Fig. 12 7.
With the feeler gauge inserted, loosen the adjusting screw of the cross head. Make sure that the feeler gauge does not feel loose. NOTE: If it is loose, repeat these steps from 5. 8. Tighten the adjusting screw of the cross head until the feeler gauge does not move. 9. While loosening the adjusting screw of the cross head gradually, adjust the valve clearance. Tighten the lock nut of the cross head when the feeler gauge feels correct. Fig. 13 START FEELER GAUGE ADHESION NO MOVEMENT NUT FIXING POSITION NOTE: G The feeling of the feeler gauge during clear- ance adjustment is same as before. PROPER CONTACT FEELING IS SAME G Do not overloosen the adjusting screw.
Overloosening of the adjusting screw will cause the same condition as in 5 again. The feeler gauge may feel correct, but there may be excessive clearance between the adjust- ing screw of the cross head and the valve. This does not allow for correct adjustment. LOOSENING AMOUNT OF ADJUSTING SCREW LARGE => Fig. 14 SM3-J007 Tightening torque : 250 kg·cm (18 lb·ft) Fig. 15 ADHESION 10mm or more