1 page 1 3-18-4 ENGINE Models J08C-TP and J08C-TR G The adjustable valve clearances when either the No.1 or No.6 piston is at the top dead center of the compression stroke are shown in the following chart. After completing the valve clearance adjustment when the No.1 piston is at the top dead center of the compression stroke, turn the crank- shaft one complete revolution and make the No.6 piston be at the top dead center of the compression stroke (The arrow printed on the camshaft points down and the underline is horizontal) and adjust the rest of the valve clearances. G : Adjustable valve clearance Fig.
16 Cylinder 1 2 3 4 5 6 Valve IN EX IN EX IN EX IN EX IN EX IN EX With No.1 piston at T.D.C. on compression stroke Camshaft gear condition Arrow points up and underline is horizontal. G G G G G G With No.6 piston at T.D.C. on compression stroke Arrow points down and under- line is horizontal. G G G G G G 10. Finally, tighten all the lock nuts of the rocker arm and ROCKER ARM CROSS HEAD the cross head with the following torques and make sure that they are all tight (the nuts do not turn). NOTE: Never overtighten with more than the follow ing torque. Final confirmed torque : 280 kg·cm (20 lb·ft) ROCKER ARM CROSS HEAD