1 page 1 Models J08C-TP and J08C-TR ENGINE 3-18-5 INJECTION TIMING ADJUSTING PROCEDURES INSPECT THE INJECTION TIMING 1. Turn the crankshaft clockwise (viewed from the crankshaft pulley side) to align the timing mark on the outer periphery of the flywheel at 3° before the top dead center of the compression stroke with the pointer of the flywheel housing. SM3-J808 Fig. 17 2. Check that the injection timing mark on the automatic timer is aligned with the pointer of the pump. If not, adjust the injection timing as described on the following page. Fig. 18 ADJUST THE INJECTION TIMING 1. Make sure that the timing mark on the outer periph- ery of the flywheel is aligned with the timing pointer. Fig.
19 SM3-J808 2. Loosen the two adjusting bolts of the injection pump coupling. Do not remove the bolts. 3. Turn the automatic timer to the left (counterclockwise viewed from the drive shaft) to align the automatic timer mark with the pointer of the pump. 4. Tighten the coupling bolt to the specified torque. Tightening torque: 950 kg·cm (69 lb·ft) Fig. 20 NOTE: No clearance is allowed between thin plates. No deformation of the flange is allowed due to distortion of a thin plate. Special tool: Injection pump coupling wrench (09511- 2500)