Hino J08C-TP, J08C-TR — ENGINE TUNEUP

1 page 1 3-18-6 ENGINE Models J08C-TP and J08C-TR START THE ENGINE WARNING Do not leave tools on or around the engine. Con- tact of tools with moving parts may result in injury or damage to equipment. PREPARATION 1. Supply engine oil. 2. Supply cooling water and bleed air from it. 3. Bleed air from the fuel system. (Refer to FUEL SYS- TEM.) 4. Check the injection timing. 5. Check the valve clearance. 6. Check connection to the alternator. NOTE: Starting the engine without the wiring in place may burn out the alternator. 7. Check the engine stopping performance. A C B CHECK THE ROCKER ARM LUBRICATION 1. Remove the head cover. 2. Set the engine revolution to the specified idling revo- lution.

3. After the engine starts, check that oil is supplied to the following locations of all rocker arms within ap- proximately 10 seconds. 1) Roller and cam face A 2) Cross head top C and spring upper seat top face D through adjusting screw B D CAM ROLLER NOTE: If the supply of oil is delayed or not happen- ing, hydraulic pressure may be low or the oil gallery may be clogged. Insufficient supply of oil may lead to seizure, abnormal wear or ab- normal noise. Recheck the assembly. OIL FILM IS CONTINUOUS OIL FILM IS NOT CONTINUOUS GOOD EXAMPLE BAD EXAMPLE Fig. 22 SM3-J020 SM3-J015 SM3-J016 SM3-J017 SM3-J018 SM3-J019 Fig. 21