1 page 1 Models J08C-TP and J08C-TR ENGINE 3-19-1 MOUNTING OF THE ENGINE ASSEMBLY 1. INSTALL THE AIR CONDITIONER COMPRESSOR. 1. Install the air conditioner compressor assembly. Tightening torque : 300 kg·cm (21 lb·ft) 2. Install the V-belt, and adjust the belt tension. Turn the adjusting bolt until the V-belt is taut, then tighten the tension pulley lock nut. Tightening torque : 420 kg·cm (30 lb·ft) 3. V-belt deflection Apply a load of about 10 kg (22 lb) by pressing with your thumb (or special tool). Assembly standard: 11 mm (0.434 in.) AIR CONDITIONER COMPRESSOR ASSEMBLY PRESSING V-BELT DEFLECTION CRANKSHAFT PULLEY TENSION PULLEY LOCK NUT ADJUSTING BOLT SM3-J795 Fig. 1 2.
INSTALL THE CLUTCH DISC AND CLUTCH COVER. NOTE: G Center the clutch disc. G Refer to CLUTCH in CHAPTER 5. SM3-J746 Fig. 2 3. INSTALL THE RADIATOR AND INTERCOOLER. 1. After installing the radiator hose and intercooler hose at the engine side, fix them with clamps. NOTE: Place a hoist on the radiator. 2. After inserting the radiator side fan shroud into the engine side securely, fix it with the clamp. Fig. 3 SM3-J604 4. INSTALL THE ENGINE ASSEMBLY. 1. Lift up the engine hanger at the front and rear end of the engine using a hoist and install it on the frame. 2. Tighten the engine mounting nut to the following torque. Tightening torque: Engine side: 1,200 kg·cm (87 lb·ft) Chassis side:
750 kg·cm (54 lb·ft) Fig. 4 SM3-J503