Hino J08C-TP, J08C-TR — MOUNTING OF THE ENGINE ASSEMBLY

1 page 1 3-19-2 ENGINE Models J08C-TP and J08C-TR 5. INSTALL THE TRANSMISSION. 1. Engage the jack in the flywheel housing bottom sur- face. 2. Engage the transmission jack in the transmission. 3. Mount the transmission to the engine, and tighten the clutch housing mounting bolt to the specified torque. SM3-J747 Fig. 5 NOTE: G Apply grease to the input shaft spline. G Refer to TRANSMISSION in CHAPTER 7. G Be sure to install the transmission straight while matching the engine angle with the transmission angle using a jack. 6. INSTALL THE PROPELLER SHAFT. 1. Tighten the flange nut to the specified torque below. NOTE: Use a hoist for the propeller shaft. Tightening torque:

650 - 870 kg·cm (47 - 62 lb·ft) 1,300 - 1,600 kg·cm (94 - 115 lb·ft) for model SG only 2. Tighten the center bearing support mounting nut to the following torque. Tightening torque: 380 - 500 kg·cm (28 - 36 lb·ft) 650 - 870 kg·cm (47 - 62 lb·ft) for model SG only 7. INSTALL THE EXHAUST PIPE AND MUFFLER. NOTE: Refer to EXHAUST SYSTEM in CHAPTER 15. Fig. 8 SM3-J502 Fig. 6 SM3-J602 Fig. 7 SM3-J6 01A