Hino J08C-TP, J08C-TR — POWER TAKE-OFF

1 page 1 Models J08C-TP and J08C-TR 3-21-2 ENGINE REMOVING 1. REMOVE THE OUTPUT COUPLING. SM3-J452 Fig. 2 2. REMOVE THE GEAR COVER. 1. Remove the flange bolt. SM3-J453 Fig. 3 2. Use flathead screwdrivers to pry up the rim of the gear cover from the gear case at the gaps, making sure to pry up by an even amount at each gap until the gear cover comes off. NOTE: When removing the gasket, be careful to ensure that no dirt from the gasket gets inside the case. SM3-J454 Fig. 4 3. USE A FLATHEAD SCREWDRIVER TO PRY OFF EVENLY THE BASE OF THE OIL SEAL UNTIL THE OIL SEAL COMES OFF. Fig. 5 SM3-J455 IDENTIFICATION PAINT COLOR: YELLOW INSTALLING THE NEW OIL SEAL 1.

USING THE SPECIAL TOOL, PRESSURE MOUNT A NEW OIL SEAL ON THE GEAR COVER. Special tool: Press (09482-2120) NOTE: DUST LIP MAIN LIP SUB-LIP G Apply lithium grease between the main lip and sub- lip of the new oil seal and to the back of the main lip. G Do not use too much grease. Also, apply grease evenly around entire circumference. Fig. 6 SM3-J456