Hino J08C-TP, J08C-TR — POWER TAKE-OFF

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-21-3 NOTE: G To prevent gouging of the rubber around the outside edge of the oil seal, apply engine oil to the portion of the gear cover where the oil seal will be pressure mounted. G Align the edges of the oil seal and gear cover. G After inserting the oil seal, completely wipe away any oil that has oozed out using a rag. SM3-J457 Fig. 7 2. MOUNTING THE GEAR COVER 1. While paying careful attention to the position of the gear case, mount the gear cover. NOTE: Mount the gear cover within 20 minutes of apply- ing liquid gasket to the gear cover. (See "Liquid Gasket and Application.") 2. Tighten the flange bolts evenly. Tightening torque:

290 kg·cm (20.5 lb·ft) Fig. 8 SM3-J458 3. MOUNT THE OUTPUT COUPLING. Tightening torque: 2,300 kg·cm (165 lb·ft) Fig. 9 SM3-J459