Hino J08C-TP, J08C-TR — ENGINE OVERHAUL CRITERIA

1 page 1 Models J08C-TP and J08C-TR 3-3-2 ENGINE (2) Measurement 1. Insert the gauge adaptor into the nozzle holder hole. Special tool: Compression gauge adaptor (09552 - 1090) (09552 - 1060) (09552 - 1030) 2. Run the engine with the starter and measure the compression pressure. NOTE: Do not operate the starter for more than 15 sec- onds. 3. Measure the compression pressure of each cylinder. NOTE: Do not allow gas leakage from the seal face. SM3-J581 Fig. 2 Unit: kg/cm 2 (lb/sq.in.) (3) After measurement 1. Install the removed parts.

WARNING Do not connect the electric harness with the en- gine stop motor while the engine starter key is at ON position as this may operate the engine stop motor instantaneously and the link lever of the engine stop motor and the engine stop lever of the fuel injection pump will move, resulting in your fingers caught by the lever. Fig. 3 SM3-J580 Assembly standard Assembly limit Difference among individual cylinders Engine speed (rpm) 35 - 38 (498-540) 28 (398) Less than 3 (43) 180 - 220