Hino J08C-TP, J08C-TR — REMOVAL OF THE ENGINE COMPONENT PARTS

1 page 1 Models J08C-TP and J08C-TR 3-5-2 ENGINE 5. REMOVE THE INTAKE MANIFOLD. SM3-J613 Fig. 6 6. REMOVE THE INJECTION PUMP. 1. Remove the through bolt of the coupling. Fig. 7 SM3-J610A 2. Use the following special tool and loosen the adjust- ing bolt. Special tool: Injection pump coupling wrench (09511 - 2500) Fig. 8 SM3-J611C 3. Remove the mounting bolt of the injection pump, then remove the pump assembly. NOTE: Cover openings to prevent foreign matter from entering. Fig. 9 SM3-J612 7. REMOVE THE AIR COMPRESSOR. 1. Remove the oil lines, refrigerant lines and air lines. 2. Remove the air compressor. 3. Remove the mounting bolt of the air compressor, then remove the air compressor. NOTE:

Do not remove the air compressor forcefully. The spigot may be damaged, or oil leakage may oc- cur due to removal of liquid gasket between the flywheel housing and the rear end plate. Fig. 10 SM3-J614