1 page 1 Models J08C-TP and J08C-TR ENGINE 3-6-3 DISMOUNTING 1. REMOVE THE CYLINDER HEAD COVER. NOTE: Clean all dust from around the cylinder head cover before removing it to prevent foreign parti- cles from getting in. SM3-J623 Fig. 3 2. REMOVE THE INJECTION NOZZLE. 1. Remove the leakage pipe. 2. Loosen the injection pipe nut. 3. Remove the injection pipe seal mounting bolts. Re- move the injection pipe seal together with the injec- tion pipe out of the cam housing. 4. Remove the nozzle clamp bolt. NOZZLE CLAMP BOLT LEAKAGE PIPE CAM HOUSING O-RING NOZZLE HOLDER ASSEMBLY Fig. 4 SM3-J178 5. Pull out the nozzle holder assembly, avoiding any interference. NOTE:
If difficult, use a special tool, sliding hammer (09420 - 1442), for easier removal. 6. Remove the O-ring. NOTE: Replace the O-ring with a new one. Fig. 5 SM3-J624