1 page 1 Models J08C-TP and J08C-TR 3-6-4 ENGINE 3. LOOSEN THE VALVE CLEARANCE ADJUSTING SCREW. 1. Loosen the lock nut at the top of the rocker arm, then wind up the adjusting screw completely. NOTE: If the adjusting screw is left unwound, the rocker shaft may bend when the rocker arm support is loosened. ADJUSTING SCREW LOCK NUT SM3-J056 Fig. 6 4. REMOVE THE ROCKER ARM ASSEMBLY. 1. Remove the rocker arm support bolt in the order as shown in the figure. NOTE: When the rocker arm assembly is removed, the rocker arm and rocker arm support tend to come off the rocker shaft. Be careful in handling. ROCKER ARM SUPPORT 1 2 4 6 7 5 3 SM3-J266 Fig. 7 5. REMOVE THE CAMSHAFT. 1.
Remove the cam bearing cap bolt. 2. Remove the camshaft together with the gear. NOTE: Be extremely careful not to drop any part into the interior of the engine. Fig. 8 SM3-J625 6. REMOVE THE CAM HOUSING. 1. Remove the cam housing bolts. 2. Tap and remove the cam housing with a plastic ham- mer. Fig. 9 SM3-J626 7. REMOVE THE CYLINDER HEAD BOLTS. Remove the cylinder head bolts in the or- der as shown in the figure. Fig. 10 SM3-J276B