1 page 1 Models J08C-TP and J08C-TR ENGINE 3-6-13 2. Install an O-ring to the nozzle sleeve insert hole of the cylinder head. Then apply liquid gasket (Three Bond No. 1211 or equivalent) to the bottom of a new nozzle sleeve, and insert it to the nozzle sleeve in- sert hole of the cylinder head. NOTE: Be sure to install a new O-ring. Reused O-rings may cause water or gas leakage and lead to over- heating or cracked heads. CYLINDER HEAD O-RING NOZZLE SLEEVE SM3-J071 Fig. 40 3. Caulk the nozzle sleeve with the special tool. Special tool: Sleeve bar (09472 - 1210) Steel ball (9800 - 06100) SPECIAL TOOL NOZZLE SLEEVE CYLINDER HEAD SPECIAL TOOL SM3-J072 Fig. 41 4.
Install the injection nozzle to the cylinder head. Then measure the protrusion of the injection nozzle from the lower surface of the cylinder head with a vernier caliper. If the value exceeds the service limit, replace the injection nozzle. NOTE: Refer to page 3-12-5. Assembly standard: 2.25 - 2.75 mm (0.0886 - 0.1082 in.) Service limit: 2.75 mm (0.1082 in.) CYLINDER HEAD Fig. 42 SM3-J100 MEASURE THE CLEARANCE BETWEEN THE CAM IDLER GEAR SHAFT AND CAM IDLER GEAR BUSHING. 1. Measure the outside diameter of the cam idler gear shaft with a micrometer. If the value exceeds the service limit, replace the cam idler gear shaft. Assembly standard: 34.0 mm (1.3386 in.) Service limit:
33.95 mm (1.3366 in.) 2. Measure the inside diameter of the cam idler gear bushing with a cylinder gauge. If the value exceeds the service limit, replace the cam idler gear. Assembly standard: 34.0 mm (1.339 in.) Service limit: 34.025 mm (1.340 in.) 3. Calculate the clearance between the idler gear shaft and idler gear bushing. If the value exceeds the serv- ice limit, replace the idler gear shaft and/or idler gear bushing. Assembly standard: 0.025 - 0.075 mm (0.0010-0.0029 in.) Service limit: 0.20 mm (0.0079 in.) Fig. 43 SM3-J142 Fig. 44 SM3-J634