Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR 3-6-12 ENGINE 2. Measure the valve spring tension at a specified length with the valve spring tester. If the spring force is lower than the service limit, replace it. SM3-J098 Fig. 37 3. Visually check the contact surface of the upper and lower valve spring seats. Replacement is necessary if damage such as wear and scratches is excessive. SM3-J099 Fig. 38 INSPECT THE CYLINDER HEAD COOLANT GALLERY FOR LEAKS. Close all coolant holes and apply air pressure of about 2.5 kg/cm 2 (36 lb/sq. in.) from one of the coolant holes. Immerse the cylinder head into the water, then check for air leakage. If any leakage is found, replace the cylinder head.

IF NECESSARY, REPLACE THE NOZZLE SLEEVE. 1. Engage a tap to the nozzle sleeve from the bottom of the cylinder head. Screw in an appropriate bolt, then strike the bolt head with a hammer and drive out the nozzle sleeve. WARNING When striking, a metal tip may fly off on impact. Wear safety glasses to protect your eyes. Fig.

39 Free length mm (in.) Setting height mm (in.) Setting load kg (lb) Nominal dimension Service limit Nominal dimension Service limit Outer spring Intake 75.7 (2.980) 75.4 (2.968) 46.8 (1.843) 46.4 (102.23) — Exhaust 75.7 (2.980) 75.4 (2.968) 46.8 (1.843) 44.2 (97.44) — Inner spring Intake 64.6 (2.543) 64.3 (2.531) 44.8 (1.764) 21.7 (47.85) — Exhaust 64.6 (2.543) 64.3 (2.531) 44.8 (1.764) 20.4 (44.98) — SM3-J069 SM3-J070