Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-6-11 3. Press fit a new valve guide straight allowing it to pro- trude as shown in the figure. NOTE: Apply engine oil lightly to the valve guide outer circumference before installation. INTAKE EXHAUST SM3-J065 Fig. 33 VALVE STEM SEAL IF NECESSARY, REPLACE THE VALVE STEM SEAL. Replace the valve stem seal when the valve guide is re- placed or when seal clearance is excessive or the stem seal has been worn or damaged. First, install the lower spring seat and valve to the cylin- der head (for guide of special tool), then apply engine oil to the lip of the stem seal and drive the guide with a spe- cial tool. Special tool:

Valve stem seal press (09472 - 2100) VALVE SPRING SEAT LOWER SPECIAL TOOL VALVE SM3-J068 Fig. 34 WARNING When striking, a metal tip may fly off on impact. Wear safety glasses to protect your eyes. COAT OIL NOTE: B G After installing the valve stem seal, make sure there is a gap (A) and (B) as shown in the figure. G Do not use the special tool if its surface contacting the valve spring lower seat is deformed. A Fig. 35 SM3-J068 INSPECT THE VALVE SPRINGS. 1. Check the valve springs for squareness using a square and a thickness gauge. If a spring is out of square beyond the service limit, replace it. Limit: 2.0 mm (0.078 in.) or more Fig. 36 SM3-J098