Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR 3-6-10 ENGINE MEASURE THE VALVE SINK. Assembly standard: Intake: 0.55 - 0.85 mm (0.0217 - 0.0334 in.) Exhaust: 1.05 - 1.35 mm (0.0414 - 0.0531 in.) Repair limit: Intake: 1.1 mm (0.0433 in.) Exhaust: 1.6 mm (0.0630 in.) NOTE: VALVE SEAT VALVE SINK DIMENSION CYLINDER HEAD VALVE SM3-J508 Fig. 29 G If the valve heads are protruding from cylinder head surface, the valve heads may hit against the pistons while the engine is running. G Following replacement of valve and valve seat, always recheck the seating condition. MEASURE THE CLEARANCE BETWEEN THE VALVE STEM AND VALVE GUIDE. 1. Measure the outside diameter of the valve stem with a micrometer.

If the value exceeds the service limit, replace the valve. Nominal dimension: 7.0 mm (0.2756 in.) Service limit: Intake 6.92 mm (0.2724 in.) Exhaust 6.84 mm (0.2693 in.) SM3-J509 Fig. 30 2. Calculate the clearance between the valve stem and valve guide. If the clearance exceeds the service limit, replace the valve or valve guide. Nominal dimension: Intake: 0.023 - 0.058 mm (0.0010 - 0.0022 in.) Exhaust: 0.037 - 0.067 mm (0.0015 - 0.0026 in.) Service limit: Intake: 0.10 mm (0.0039 in.) Exhaust: 0.12 mm (0.0047 in.) 90° SM3-J510 Fig. 31 IF NECESSARY, REPLACE THE VALVE GUIDE. 1. Remove the valve stem seal. 2. Strike the valve guide out with a brass bar and a hammer.

WARNING When striking, a metal tip may fly off on impact. Wear safety glasses to protect your eyes. Fig. 32 SM3-J511