Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-6-9 Assembly standard: Valve seat (Intake): 30°00' - 30°35' Valve face (Intake): 29°30' - 30°00' Valve seat (Exhaust): 45°00' - 45°30' Valve face (Exhaust): 44°30' - 45°00' EXHAUST INTAKE SM3-J097 Fig. 25 BLOCK BRASS IF NECESSARY, REPLACE THE VALVE SEAT. 1. Cut three places on the circumference of an un- wanted valve and weld it to the valve seat. NOTE: To protect the lower surface of the cylinder head from welding spatter, be sure to apply grease before welding. 2. Place a back plate at the top of the valve stem and strike it with a hammer to remove the valve seat. NOTE: When striking, a metal tip may fly off on impact.

Wear safety glasses to protect your eyes. HAMMER VALVE SEAT ELECTRIC WELDING APPLIED VALVE GRIND THIS POINT WITH A GRINDER SM3-J064 Fig. 26 3. Machine the valve seat according to the specified valve seat dimensions. Dimensions of the valve seat machining: C C EXHAUST INTAKE SM3-J065 Fig. 27 4. Heat the cylinder head to approx. 80°C (176°F) - 90°C (194°F) with hot water. Cool the valve seat with dry ice for approx. 30 minutes. Hold the seat with pincers and place it into the heated cylinder head. The valve seat can be easily made to fit by lightly hitting it. WARNING G Never touch the cooled valve seat with your bear hands. G When striking, a metal tip may fly off on impact.

Wear safety glasses to protect your eyes. G Following valve grinding, always recheck the SM3-J066 Fig. 28 seating condition. Intake Exhaust Unit:mm Unit:in. Unit:mm Unit:in. Clynder head side A 41-41.016 1.6142-1.6148 39-39.016 1.5355-1.5360 B 9.4-9.6 0.3701-0.3779 8.6-8.8 0.3386-0.3464 Valve seat side C 41.085-41.1 1.6176-1.6181 39.12-39.135 1.5402-1.5407 D 7-7.2 0.2756-0.2834 6-6.2 0.2363-0.2440