Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR 3-6-8 ENGINE INSPECT THE VALVE CONTACT SURFACES FOR PROPER CONTACT. 1. Visually check valves for damage, burn marks, car- bon accumulation, warpage, or cracks in valve heads, valve stems, and valve stem grooves. Replace valves which are excessively worn, burnt, warped or cracked. SM3-J631 Fig. 21 2. Check the valve seating condition. Lightly apply red lead marking compound to the valve face. Install the valve with a special tool, tap and rotate the valve against the seat. Check the valve face and valve seat for seating. When the red lead mark is not concentric or even all around the valve face or seat, correct the valve face or the valve seat.

Special tool: Valve lapping tool (09431 - 1020) SM3-J104 Fig. 22 HAND-LAP THE VALVE AND VALVE SEAT. Lightly apply lapping compound to the valve face. Install the valve with a special tool, tap and rotate the valve against the seat. NOTE: G Following completion of hand-lapping, clean off any lapping compound which has adhered to the valves and valve seats. G Following hand-lapping, always recheck the seating condition. Special tool: Valve lapping tool (09431 - 1020) Fig. 23 SM3-J632 GRIND VALVES NOTE: G Grinding of valves should only be performed when hand-lapping does not result in proper seating. G Following hand-lapping, always recheck the seating condition.

WARNING When grinding, a metal tip may fly off on impact. Wear safety glasses to protect your eyes. Fig. 24 SM3-J507A SM3-J507