Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-6-7 INSPECTION AND REPAIR CYLINDER HEAD NOTE: G Clean the cylinder head thoroughly with a commercial cleaning agent before inspection. G Do not damage the lower surface of the cylinder head. SM3-J062 Fig. 16 INSPECT THE CYLINDER HEAD FOR CRACKS. Check the head surface and intake and exhaust valve seats, for cracks, using a dye penetrant. If cracks are found, replace the cylinder head. SM3-J103 Fig. 17 CHECK THE CYLINDER HEAD FLATNESS. 1. Check the cylinder head surface for flatness with a straight edge and a thickness gauge. If the meas- urements exceed service limits, replace the cylinder head. Standard:

0.06 mm (0.0024 in.) or less for longitudinal di- rection 0.03 mm (0.0012 in.) or less for lateral direc- tion Service limit: 0.20 mm (0.0079 in.) SM3-J630 Fig. 18 B C D A E F G Fig. 19 SM3-J505 2. Check the flatness of the intake and exhaust mani- folds mounting surfaces. Standard: 0.06 mm (0.0024 in.) or less for longitudinal di- rection 0.03 mm (0.0012 in.) or less for lateral direc- tion Service limit: 0.20 mm (0.0079 in.) Fig. 20 SM3-J506