Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-6-15 2. Measure the cam height. Measure the dimensions (A) shown in the figure with a micrometer. If the value exceeds the service limit, replace the camshaft. Nominal dimension A : Intake = 50.0667 ± 0.15 mm (1.9711 ± 0.0059 in.) Exhaust = 52.1038 ± 0.15 mm (2.0513 ± 0.0059 in.) Service limit: –0.5 mm (–0.0197 in.) SM3-J636 Fig. 49 SM3-J519A Fig. 50 3. Measure the clearance of camshaft journal. a. Measure the outside diameter of camshaft journal with a micrometer. If the value exceeds the service limit, replace the camshaft. Nominal dimension: 40.0 mm (1.575 in.) Service limit: 39.85 mm (1.569 in.) b.

Measure the inside camshaft bearing with a cylinder gauge. If the value exceeds the service limit, replace the camshaft bearing. Nominal dimension: 40.0 mm (1.575 in.) Service limit: 40.15 mm (1.581 in.) c. Calculate the clearance from the above measure- ment. If the clearance is greater than the limit, re- place the camshaft or camshaft bearing. Nominal dimension: 0.020 - 0.063 mm (0.0008 - 0.0024 in.) Service limit: 0.1 mm (0.0039 in.) SM3-J637 Fig. 51 SM3-J638 Fig. 52