1 page 1 Models J08C-TP and J08C-TR 3-6-24 ENGINE 11. INSTALL THE CYLINDER HEAD COVER 1. Remove the cylindrical plugs at the front and rear ends of the cam housing. Clean the cylindrical plugs and the mounting surfaces of the cam housing. HEAD COVER CAM HOUSING CYLINDRICAL PLUG SM3-J085 Fig. 80 2. Apply liquid gasket to the front and rear half circles of the cam housing, then install the cylinder plug within 20 minutes. Liquid gasket: ThreeBond No.1207B Coating width: 1.5 - 2.5 mm (0.06 - 0.10 in.) NOTE:
CYLINDRICAL PLUG PHASE WHERE NOT APPLIED LIQUID GASKET GOOD COARSE PHASE WHERE TO APPLY LIQUID GASKET G If left more than 20 minutes, clean off the liquid gas- ket completely and reapply the liquid gasket. G Make sure to wipe off excessive liquid gasket. G Refer to page 3-20-1. SM3-J086 Fig. 81 3. Apply liquid gasket to plug corner A at the front and rear ends of the cam housing. CLINDRICAL PLUG A CAM HOUSING SM3-J087 Fig. 82 4. Install the cylinder head cover gasket into the gas- ket groove at the head cover lower surface. 5. Insert the spacer from the head cover lower surface. 6. Install the cylinder head cover to the cam housing. NOTE:
If left more than 20 minutes, clean off the liquid gasket completely and reapply the liquid gasket. 7. Tighten the mounting bolt of the head cover through the silent block to the specified torque below and fix the head cover on the cam housing. Tightening torque: 250 kg·cm (18 lb·ft) BOLT HEAD COVER SILENT BLOCK HEAD COVER GASKET SPACER BOTTOM FACE OF HEAD COVER CAM HOUSING SM3-J088 Fig. 83