Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-6-23 8. INSTALL THE ROCKER ARM ASSEMBLY. 1. Install the rocker arm assembly to the cylinder head. Make sure that the cross head is on each valve. NOTE: If the cross head is assembled off the valve, the valve may fall off, resulting in engine damage. Tightening torque: 480 kg·cm (35 lb·ft) 6 4 2 1 3 5 7 SM3-J270 Fig. 77 9. INSTALL THE INJECTION NOZZLE. 1. Install a new O-ring into the groove of the cylinder head. 2.

Make sure that there is no dirt or foreign particles at the sealing part between the nozzle holder and re- lated parts (O-ring, nozzle sleeve and injection pipe seal), and connecting part between the nozzle holder and nut of the injection pipe. 3. Insert the nozzle holder taking care not to contact the valve spring as shown in the figure. NOTE: Apply clean engine oil to the O-ring and be care- ful that the O-ring is not caught. 4. Cover the end of the injection pipe seal with the noz- zle holder as shown in the figure and tighten the bolts to fasten the injection pipe seal to the cam housing. 5. Tighten the nut of the injection pipe provisionally. 6.

Tighten the nozzle clamp bolt to the specified torque. Tightening torque: 250 kg·cm (18 lb·ft) NOTE: After tightening the bolt, make sure that the rocker arm moves smoothly. 7. Tighten the nut of the injection pipe to the specified torque. Tightening torque: 400 kg·cm (28 lb·ft) 8. Install the leakage pipe. SM3-J199 VALVE SPRING INJECTION PIPE NUT ROCKER ARM INJECTION PIPE SEAL LEAKAGE PIPE NOZZLE CLAMP BOLT CAM HOUSING Fig. 78 10. ADJUST THE VALVE CLEARANCE. NOTE: Refer to page 3-18-4. SM3-J651 Fig. 79