Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR 3-6-22 ENGINE 2. Install the cam housing on the cylinder head. NOTE: When installing the cam housing, make sure the cam housing gasket is correctly fitted and is free of uneven deformation. SM3-J647 Fig. 72 5. ASSEMBLE THE CAMSHAFT. 1. Install the camshaft into the cam housing so that the arrow stamped on the front of the camshaft gear faces upward and that the lower line is level. NOTE: Incorrect installation may damage of the engine. ARROW OF MARK SCALE ETC... SM3-J083 Fig. 73 2. Install the camshaft bearing cap to the cam hous- ing. Make sure there is no dirt or scratch on the tight- ening surfaces. 3.

Apply clean engine oil to the bolt seating and bolt thread, then tighten the bolt to the specified torque below. Tightening torque: 320 kg·cm (23 lb·ft) Fig. 74 SM3-J648 6. MEASURE THE BACKLASH BETWEEN THE CAM- SHAFT GEAR AND CAMSHAFT IDLER GEAR. Measure the backlash between the camshaft gear and camshaft idler gear with a dial gauge. If the value exceeds the service limit, replace the camshaft gear. Nominal backlash: 0.030 - 0.253 mm (0.0012 - 0.0099 in.) Service limit: 0.30 mm (0.0118 in.) Fig. 75 SM3-J649 7. MEASURE THE CAMSHAFT END PLAY. Measure the thrust clearance between the camshaft and camshaft bearing with a dial gauge.

If the clearance ex- ceeds the service limit, replace the camshaft. Nominal clearance: 0.10 - 0.178 mm (0.0040 - 0.007 in.) Service limit: 0.3 mm (0.0118 in.) Fig. 76 SM3-J650