1 page 1 Models J08C-TP and J08C-TR ENGINE 3-6-21 c. Apply clean engine oil to the bolt surface and bolt threads. NOTE: Since the cylinder head bolts are unique to this engine, do not substitute ordinary bolts. 2. Tighten the cylinder head bolt. a. Tighten No.1 - No.26 (M12) bolts in the order shown in the figure to the specified torque below. Tightening torque: 600 kg·cm (43 lb.in.) Fig. 68 SM3-J269B b. Mark the bolts with paint to indicate the same direc- tions as shown in the figure. c. Turn No.1 - No.26 bolts 90° (1/4 turn). d. Retighten them 90° (1/4 turn). NOTE: Total tightening amounts to 180°. It must not be- come 200° or more. e.
Make sure that all paint marks face the same direc- tion. NOTE: When adding torque, never untighten the nuts, even if they have been overtightened. PAINT Fig. 69 SM3-J078 f. Tighten No.27 - No.29 (M10) bolts in the order shown in the figure to the specified torque below. Tightening torque: 600 kg·cm (43 lb·ft) SM3-J288A Fig. 70 4. INSTALL THE CAM HOUSING. 1. Using the timing line on the flywheel, align No.1 cyl- inder with the upper dead point. NOTE: Refer to page 3-18-1. FLYWHEEL HOUSING FLYWHEEL SM3-J009 Fig.71